Write to us
ul.Jankowicka 19
44-321 Marklowice
Capacity up to 120 pph
The device is used to apply lids on plastic cups previously sealed with foil or aluminum plate. The cups are fed to the input conveyor of the NP-6 from the preceding conveyor aligning them in one lane. Then they are transferred by screws in cycles each 2,5 seconds of 6 pieces to a chain conveyor with grippers. The grippers move packages under the arm that applies the lids on. After the lids are put and snapped on, the cups in one lane go onto the customer's collecting conveyor.
Efficiency: up to 120 packages / minute.
The width of aligning conveyor belt: about 200 mm.
Plastic packaging: cup + lid
Capacity up to: 120 packs / min.
depending on :
• speed and quality of packages fed from the sealing machine
• quality of the lids
• operator placing the lid into the magazine
Package:
• plastic snap-on lid
• packaging adapted to work in automatic feeders
Number of lids applied in 1 cycle 6
Conveyor belts (input) 1 set
Ingress protection IP 65
Dimensions ~ 3500x900x2450mm
Servo-drives SCHNEIDER
Made of SS AISI 304 Anodized aluminum
Compressed air: min. 0,6 MPa
Installed power ~ 1,7 kW
Electricity: 400V/50Hz
Control PLC Siemens
Touch screen panel SIEMENS
Remote modem Ethernet
Electronic components: TELEMECANIQUE OMRON, SCHNEIDER
Synchronization with the sealing device: Relay contacts